18
MT- S
2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE
T R
Telemetry System with Sanwa Synchronized Link Support
4) Press the UP or DOWN keys to highlight the ENTER command. Do not press the
ENTER key yet.
Verify that the Modulation Type is set to RF MODE : FH4T and that the Channel
Response Mode for each channel is set to NOR. If you need to change any of
these settings, see the BIND Menu section on pages 55 and 56.
3) Press
the ENTER key to open the SYSTEM menu, then press the ENTER key to open
the BIND menu.
5) While holding down the Bind Button on the receiver, turn the receiver ON. The
Bind LED on the receiver will flash slowly. Release the Bind Button. The Bind
LED will continue to flash slowly.
You must complete step 5 below within 10 seconds or the Bind LED will
go out, indicating the receiver has timed out. If this occurs, turn the
receiver OFF, then repeat step 4.
8) Move the Steering Wheel and Throttle Trigger to verify that the servos are operating normally, then repeatedly press and
HOLD the BACK key to return to the STATUS screen.
Under some circumstances, the receiver may not operate after turning the transmitter and receiver ON. If this occurs,
perform the Binding procedure again.
6) With ENTER highlighted, press the ENTER key. The ENTER command and the LED
on the transmitter will begin to flash and the Bind LED on the receiver will flash
rapidly, then go out.
7) After the Bind LED on the receiver goes out, press the ENTER key a second time. Both the Bind LED on the receiver and the
LED on transmitter will illuminate solid, indicating that the Binding procedure is complete.
The Binding function allows you to Bind the transmitter and receiver pair. When new, it is necessary to pair the transmitter and
receiver to prevent interference from transmitters operated by other users. This operation is referred to as 'Binding'. Once the
Binding procedure is complete, the setting is remembered even when the transmitter and receiver are turned OFF, therefore,
this procedure usually only needs to be done once.
Before beginning the Binding procedure, connect the switch harness, servos and the receiver battery to your receiver,
using the diagram in the Receiver Overview Diagram, Connections and Mounting section on pages 8 and 9.
Make sure
that both the transmitter and the receiver are turned OFF.
IMPORTANT:
This section details Binding the RX-482 2.4GHz FH4T Super Response SSL receiver with the Channel Response
Mode set to SHR. If you are Binding an FH3 receiver, or if you prefer to change the Channel Response Mode, see the BIND
Menu section on pages 55 and 56.
TRANSMITTER AND RECEIVER BINDING
GENERAL
1) Turn the transmitter ON. The STATUS screen should be displayed.
2) Press the ENTER key to open the PROGRAMMING screen, then press the UP or
DOWN keys to highlight the SYSTEM menu.
