11
Voice Processor 2x
Mic Output Levels
Mic Level Output
If you find it necessary to connect the 2x’s line level output(s)
to a microphone level input, you will need to sufficiently
attenuate the 2x’s outputs using internal jumpers.
WARNING!
Lethal voltages are present inside
the chassis. Perform all service work with the unit
disconnected from all AC power.
CAUTION:
These servicing instructions are for use by
qualified personnel only. To avoid electric shock, do not
perform any servicing other than that contained in the
operating instructions portion of this manual unless you
are qualified to do so. Refer all servicing to qualified service
personnel.
Tools Required
1. #2 Phillips-head screwdriver
Top Cover Removal
1. Ensure that the 2x is disconnected from the AC power
source.
2. Remove the 6-32 x 1/2 inch screw from the top panel.
3. Slide the top cover rearward and lift free of the chassis.
Changing the Output Level Jumpers
The 2x ships with the outputs configured for a line level
output. If you must have a microphone level output, the
following steps lead you through the process of switching
one or both line level outputs to microphone level (or back to
line level).
1. Remove the top cover according to the steps
outlined above.
2. Locate the output level jumpers directly behind the Analog
Out jacks by referencing the diagram provided below.
3. To convert an output to mic level output, move the two
MIC LEVEL jumpers to their right most positions and the
two +4 dBu jumpers to their left most positions.
4. Replace the top cover.
5. Reinstall the 2x to your setup.
