"RT" (Room Temperature) LED light:
The light comes on when the current room
temperature is shown.
"LO" LED:
The light comes on when the low fan speed is selected.
"HI" LED:
The light comes on when the high fan speed is selected.
"AUTO" LED:
This comes on when the (preset) AUTO MODE is selected. If the
ambient temperature is higher than 23° C the unit will work in cooling mode. If the
ambient temperature is below or equal 23° C, the unit will work in heating mode (for
the unit with heating function) or ventilation mode (for the unit without heating
function).
"COOL" LED:
Thi
s c
omes on when the cooling function is selected.
"DRY" LED:
This comes on when the dehumidifier function is selected.
"HEAT" LED:
This comes on when the heating function is selected. (for the unit
with heating function)
"TIMER" LED:
This comes on when the timer function is activated.
“
RUN” LED LIGHT:
Illuminates when the unit turns on.
If this light starts to flash, the unit will begin to beep and then shut down. This means
that the unit’s condensation tank is full and the unit cannot drain. The light will
remain flashing and the unit will remain off until the condensation water is drained
from the unit. Please refer to the CLEANING THE UNIT section in this manual for
further information.
NOTE: Sleep function
Cooling mode: The Sleep function is designed to gradually increase the
thermostat temperature by 1
° C
each hour, and hence the room temperature will
be adjusted in the first two hours only. (When the set time elapses, the unit will
shut off.)
Heating mode: The Sleep function is designed to gradually decrease the
thermostat temperature by 1
° C
each hour, and hence the room temperature will
be adjusted in the first two hours only. When the set time elapses, the unit will
shut off.
NOTE:
This unit has a three-minute compressor delay protection circuit,
consequently, the compressor may take up to three minutes to start when first turned
12
