New Master 35 Petrol/Gasoline Impact Wrench
O
OPERATING CONTROLS -
Instructions for use (See Page 3 for locations)
1. CONTROL SWITCH
Settings
STOP
RUN
CHOKE
2. DE-COMPRESSION BUTTON
To assist in easy
starting. Push in
before starting.
Comes out
Automatically when
Motor Starts.
DO NOT
use when Engine is warm
3. RECOIL STARTER HANDLE
Always
allow the Starter Cord to return
to its position under control and
DO NOT
allow it to fly back.
4.
THROTTLE TRIGGER
Depress Safety Lock 5 and squeeze Trigger
to increase Motor speed
5. TRIGGER LOCK
This is to prevent accidental acceleration
6. GEAR LEVER
This has three positions: marked
N, F and
R
N - Neutral
F - Clockwise Rotation
R - Anti-clockwise Rotation
To engage turn
fully
90° from the Neutral
position.
The gears are stationary when the Motor
is idling at tickover speed. Select the gear
required. If it will not engage, gently
squeeze the throttle trigger so the gear
parts move slightly.
7. SOCKET SQUARE DRIVE
Standard 1” Square Drive. The Accessory is
secured to the Square Drive by a Rubber
Ring and a 5mm dia Bright Steel Pin or other
suitable retaining device. If the Pin breaks or
bends examine both Accessory and Square
Drive for possible wear.
Worn Accessories damage the
Square Drive. A worn Square
Drive damages Accessories and
both create extra vibration.
Replace when worn.
Use our Master 35 No Go Gauge to check if
Anvil and Sockets are worn and need to be
replaced.
8. OIL FILLER PLUG
Use for filling, draining and indicating
Gearbox oil level.
9. FUEL FILLER CAP
Remove carefully when refilling the Fuel
Tank.
10. LOCATION OF SERIAL NUMBER
LABEL
First Serial Number for New Master 35
Impact Wrench MA20 A001
11. AIR FILTER COVER CLIPS
4
