En-4
cover. (Fig. 3)
Remove the screw at 2 places of the
wiring
hole and remove the wiring hole cover. (Fig. 2)
3
Fig1
147 (5-25/32)
84 (3-5/16)
123 (4-27/32)
211 (8-5/16)
95 (3-3/4)
95 (3-3/4)
72 (2-27/32) 72 (2-27/32)
46 (1-13/16) 46 (1-13/16)
14
8.
5 (5-27/32)
2.
5 (3/32)
Unit: mm (in.)
Installation plate
Rear cover outline
4
Fig1
9(11/32)
9(11/32)
12
6(
4-
31
/3
2)
Anchorposition
Refer to the dimensional drawing and verify the consistency of
*
the hole positions of the installation screws of the switch box to
be installed in advance. (Fig. 4)
Terminal names
51 21
Terminal names: Names of connection terminals inside
▪
the rear cover
Power supply cable
through hole
Power supply
cable connection
terminal
Transmission cable
through hole
Transmission cable
connection terminals
[TM201]
CN411
CN412
L
N
X1 X2
K1 K2 K1 K2
CH1
CH2
TRANSMISSION
EXTERNAL INPUT
[TM201]
VRF (
L
ON
W
ORKS
)
Transmission
terminal
Screw Size : M3
Earth (Ground)
terminal
Screw Size : M3
External input
terminal
Screw Size : M3
Input method:
pulse
POWER SUPPLY
Power supply
terminal
1Ø 100-240V
Screw Size : M4
Earth (Ground)
terminal
Screw Size : M4
External input function
51 31
External input terminals:
▪
Function which uses external input terminals to perform
the “Emergency stop” or “Batch start/batch stop” opera-
tion from the outside.
External input contact
▪
CH1 and CH2 of TM201 of the rear cover are switched
to "dry contact terminal" and "apply voltage terminal" by
connecting CN201 on the front cover PCB to CN411 or
CN412.
TM201- CH1, CH2
Connect with the CN201
Dry contact terminal
CN411 *
Apply voltage terminal
CN412
:Factory setting
*
Dry contact terminal
▪
When a power supply is unnecessary at the input
device you want to connect, connect CN201 and
CN411.
