En-7
Insert the connector of the connection cable.
Close the front cover and rear cover. Align the claw of
the bottom of the front cover and fit the top to the rear
cover.
Tighten the 2 screws at the side of the
@
main unit.
Transmission
cable
Transmission
cable
power supply cable
power supply
cable
Washer
Binder
Harness
Connection cable
Binder
Touch pen tray
Switch box
Hole in wall
Installation
plate
Screw
Screw
@
Installation of touch pen
(2)
Touch panel controller
Hole for strap
Hole for strap
Strap
Touch pen
There is a hole for a strap
which suspends the touch pen
at the main unit.
Use it so that the touch pen will
not be dropped or lost.
There are holes for a strap at
*
both sides of the main unit.
Install at the easiest hole to
use.
TURNING ON THE POWER
61
CAUTION
Check that the power supply voltage is within the
specified range. If a power supply voltage outside the
specification is input, it will cause trouble.
Recheck the wiring. Incorrect wiring will cause trouble.
After installation work is completed, check the following
contents:
Is touch panel controller
power supply cable and
transmission cable wiring work complete?
Does the power supply match the rating of the touch
panel controller?
Turn on the touch panel controller
main unit power.
Since there is no power switch at the main unit, turn
on the power by means of the power distribution
panel.
If the following installer setting screen is displayed at
the screen of the touch controller panel, installation
work is complete.
For setting and operating of the touch panel controller,
refer to the separate operating manual.
Since there is some kind
*
of a problem when the
installer setting screen
does not appear, recheck
the work contents.
