Ductwork Connection
Ensure ductwork is adequately sealed to the AHU and supported separately.
connection is to be of the size as recommended on our general arrangement drawing.
Electrical Connection
Do not penetrate or obst
cables
penetrate the AHU casework, ensure that the casework is
prevent air leakage/water ingress. If the unit is provided with package controls then
always use the cable en
3 Phase Motor Wiring Diagrams
IT IS IMPORTANT TO USE THE CORRECT WIRING DIAGRAM AS DETAILED BELOW
TO SUIT THE INCOMING MAINS VOLTAGE. FAILURE TO DO SO MAY RESULT IN
PERMANENT DAMAGE TO THE MOTOR/
STAR Connection (Y):
DELTA Connection (
Δ
):
Inverters
When inverters are provide
inverter to the motor will be completed at the factory, refer to inverter
documentation for wiring & setup instructions.
Loose inverters may be provided for fitting and wiring by others, refer to inve
documentation for wiring & setup instructions.
Installation, Operation & Maintenance Manual
Ensure ductwork is adequately sealed to the AHU and supported separately.
connection is to be of the size as recommended on our general arrangement drawing.
Do not penetrate or obstruct the removal of any doors/access panels
penetrate the AHU casework, ensure that the casework is adequately sealed to
prevent air leakage/water ingress. If the unit is provided with package controls then
always use the cable entry as provided.
USE THE CORRECT WIRING DIAGRAM AS DETAILED BELOW
TO SUIT THE INCOMING MAINS VOLTAGE. FAILURE TO DO SO MAY RESULT IN
PERMANENT DAMAGE TO THE MOTOR/CONTROL GEAR.
):
When inverters are provided fitted to the AHU the electrical connection from the
inverter to the motor will be completed at the factory, refer to inverter
documentation for wiring & setup instructions.
Loose inverters may be provided for fitting and wiring by others, refer to inve
documentation for wiring & setup instructions.
stallation, Operation & Maintenance Manual
8
Ensure ductwork is adequately sealed to the AHU and supported separately. Ductwork
connection is to be of the size as recommended on our general arrangement drawing.
ruct the removal of any doors/access panels. Where electrical
adequately sealed to
prevent air leakage/water ingress. If the unit is provided with package controls then
USE THE CORRECT WIRING DIAGRAM AS DETAILED BELOW
TO SUIT THE INCOMING MAINS VOLTAGE. FAILURE TO DO SO MAY RESULT IN
d fitted to the AHU the electrical connection from the
inverter to the motor will be completed at the factory, refer to inverter
Loose inverters may be provided for fitting and wiring by others, refer to inverter
