Airplane Factory SLING 2
Pilot Operating Handbook
Page | 4-20
DC-POH-002-X-B-6
Revision : 2.6
4.12.3
After landing
1. Engine speed
- set as required for taxi.
2. Wing flaps
- retract.
4.13
Baulked landing procedures
1. Throttle
- full power (maximum 5 800 rpm for
5 minutes).
2. Trim
- as required.
3. Wing flaps
- retract to 50% as soon as possible and
retract fully when reaching 65 knots (at
300 ft minimum height).
4. Electric fuel pump
- off (912 ULS) (300 ft minimum).
Auxiliary electric fuel pump
- off (912 iS / 914 UL) (300 ft minimum).
5. Propeller (if applicable)
- AUTO / CLIMB (minimum 300 ft).
6. Trim
- adjust.
7. Repeat circuit pattern.
4.14
Short field take-off and landing procedures
Not considered necessary. Ordinary short field procedures may be used if
pilot deems it appropriate.
CAUTION
Rapid engine cooling should be avoided during operation. This especially
happens during aircraft descent, taxi, low engine rpm or at engine
shutdown immediately after landing. Under normal conditions the engine
temperatures stabilize during descent and taxi at values suitable to stop
the engine (by switching the ignition off) as soon as aircraft is stopped. If
necessary (elevated engine operating temperatures), cool (for minimum
2 minutes) the engine at approximately 3 000 rpm to stabilize the
temperatures prior to engine shut down.
Summary of Contents for Sling-2
Page 1: ......
