AB1600_V0.3
2
Environment Setup
2.1
Hardware Setup
An UART interface is used for PC-to-DUT connection. User may also use an USB-to-UART adaptor at PC
side and then connect to DUT side. A reference connection diagram is shown in figure 2-1.
Figure 2-1
If an USB-to-UART adaptor made by Airoha is used (as in Figure 2-2), the J1 connector (to DUT) pin
definition is shown in Figure 2-3. The VCC selection on JP12 should be set to +3.3V (with a jumper).
BT Device
Spectrum Analyzer
Adapter board
(USB to RS232)
Signal Generator
or
Summary of Contents for AB1602
Page 5: ...AB1600_V0 3 Figure 2 2 Figure 2 3 1 2 3 4 5 6 3 3V GND RTS CTS TX RX...
Page 7: ...AB1600_V0 3 Figure 2 5...
Page 11: ...AB1600_V0 3 Figure 4 2 Continuous data transmission setting of Tx Tab...
Page 13: ...AB1600_V0 3 Figure 4 4 LE Transmitter Test setting of Tx Tab...
