page 12 of 22
Version 1.4 – June 2015
- ADS_Clinic Operator Manual _V1_4_Mai 2015_Software 1_20_ENG.doc
Turning on the device
You connect the ADS
clinic
as described above to.
You press button
(1)
for ca. 3 seconds, till the light from the display is turned
on. Once you see a number in the display, which corresponds to one of the
digits “1”, “2”, or “3”, the ADS
clinic
is ready to be set. Mutiple settings shown in
the display, after the device has been turned on, are based on it’s last usage
and before the last turning off.
Please determing yourself
:
Before turning on, the attached mattress must be connected
first. Here, the last selected mattress, will as default choice
proposed. At each mattress, a pneumatic connector is atta-
ched foreseen with the digits „1“, „2“ or „3“. These digits are
related to its mattresses.
Number
Type
Minimum weight
patient
Maximum weight
patient
1
Mattress, REF 10-8200
20 Kg
180 Kg
1
Patients replacement mattress
system (foam pocket inside for
max 6 cm foam mattress, foam
not included) REF 10-8215
20 Kg
180 Kg
2
Mattress replacement system
(support stop in June 2015)
50 Kg
210 Kg
3
Mattress replacement system
REF 10-8335
70 Kg
250 Kg
You change the selected mattress by pressing button
(10).
To set the weight of patient
you must use the button „+“ or „-„. The selected mattress type is shown in the middle of
the display (you see a large digit). The choice and the confirmation of the type, shall be
carried out by pressing the keys
(3)
or
(4)
(choice operating mode „Static“ or „Alterna-
ting mode“), each time for the operating mode for which you have selected.
The alarm, caused by a leakage, is a safety precaution against the bed sores.
When using mattress type “1” you are required to lay a mattress between the patient’s
mattress and the slatted mattress/bars.
The footage of the patients mattress is at the end, where the pneumatic connection hose
is. The headboard is located opposite the feet ends and contains no connection hose. The
top of the mattress is that side where the zipper for attachmed to the tracing (deck) is.
The tracing (deck, cover) itself has a foot end where the overprint (logo) "AirMed PLUS"
is located.
