airmaster AM 1000, Installation Manual

Page: 15 / 28

15
ceiling (2) can also be performed between the air handling
unit (1) and the wall/roof (2) at position (5) before fitting
the air handling unit.
Depending on the condition of the wall/ceiling and the
dimensions of the air handling unit, a sealant that retains
elasticity over the long term or expanding sealing tape
can be used to obtain a flexible seal. This material is to be
applied to the rear of the unit around the air connection
fittings, or at the side of the duct holes on the wall to even
out irregularities on the wall/ceiling.
3.7. Fitting of Panels
The panels must only be fitted once the unit, complete
with all equipment, has been fitted and connected, and
the functions of the unit thoroughly tested.
Press the panels to the clips on the unit until they attach
securely to the clips.
The perforated circles in the side and rear panels should
not be removed until required for ducted connections.
a: Left panel.
b: Rear panel.
c: Right panel.
D: Perforated section for extraction for DE version.
E: Perforated section for exhaust for H version.
F: Perforated section for intake for H version.
G: Perforated section for intake in S1 version or
exhaust in S1 and S2 versions.
H: Perforated section for intake for S2 version.
a
b
c
D
E
F
G
H
3.8. Installation Check
yes no
Serial number noted
Wall frame fitted
Unit fitted
Ceiling fittings attached
Ducts and grilles fitted
Roof cap fitted
Screws retightened
Panels fitted
Name of installation engineer:
Comment: