AIRLUX ATV63TBK, Operating And Maintenance

Page: 16 / 32

16
IMPORTANT NOTICE
THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED
PERSONNEL EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO
PEOPLE, ANIMALS OR THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH
SUCH PROVISIONS.
INSTRUCTIONS FOR THE INSTALLER
Installing the top
The appliance is designed to be embedded into
heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 65°C besides the room one.
The appliance is of type "Y", or it can be installed
with one side wall to the right or left of the hob.
The equipment must not be installed near
inflammable materials, such as curtains, cloths,
etc.
Make an opening in the worktop of the dimensions
indicated in fig. 3 so that there is a distance of at
least 50 mm from the rear edge of the installed
appliance and 100 mm from the adjacent side
walls.
MODEL L (mm) P (mm)
ATV63TBK
ATV63TWK
560 480
Any possible wall unit over the cook-top must be
placed at a distance of at least 760 mm from the
top.
It is advisable to isolate the appliance from the
piece of furniture below with a separator, leaving a
depression space of at least 10 mm (fig. 4).
If the hob is going to be installed on the top of an
oven, precautions must be taken to guarantee an
installation in accordance with current accident
prevention standards. Pay particular attention to
the position of the electric cable and gas pipe: they
must not touch any hot parts of the oven.
Moreover, if the hob is going to be installed on
the top of a built in oven without forced cooling
ventilation, proper air vents must be installed
to guarantee an adequate ventilation, with the
lower air entering with a cross section of at least
200cm 2 , and the higher air exiting with a cross
section of at least 60 cm 2 .
Fastening the top
Every cook-top is equipped with a special washer
having an adhesive side.
- Remove the racks and burners from the top.
- Turn the appliance upside down and lay the
adhesive washer S along the external border of
the glass (fig.5).
- Introduce and place the cook-top in the hole made
in the piece of furniture, then block it with the V
screws of the fastening hooks G (fig.6).
ATTENTION:
The electrical connection of the cooking hob
and the oven must be carried out separately for
security issues and to allow easy removal of the
oven from the unit
Installation room
This appliance is not provided with a device for
exhausting the products of combustion.
Regarding room ventilation rules where appliance
is installed make reference to the legislation, in
conformity with the local regulations.
The room where the appliance is installed must
have a minimum volume of 20m³
INSTRUCTIONS FOR THE USER
CLEANING
Gas taps
The possible lubrication of the taps must be carried
out by specialized personnel, exclusively.
In case of hardening or malfunctions
in the gas taps, apply to the Customer
Service.