1. VLAN Aware mode:
z
Enable - When Tag-VLAN function is applied on this port, user may enable VLAN Aware associated with
this port, and then ingress frames and egress frames will be handled according to the following
parameters’ setting.
z
Disable – default state, this means, switch doesn’t do VLAN tag stripping and insertion.
2. Ingress filtering:
z
Enable - Check ingress frame VLAN ID. Ingress frame will be dropped if this frame's VID is not the same
as the VID of the ingress port which belongs to a member of a ”VLAN group”
z
Disable – the Ingress frame will be flood if VID is not the same
3. Accept Packet Type:
z
ALL - Accept all ingress frames
z
Tagged only - Only accept ingress frames with VLAN tag
4. Port VID
:
Set
Port VID
= value (1 ~ 4096), then an untagged ingress frame will bear this value at its VID. Usually this
port is connected to a un-tag device (legacy device), then this frame becomes a tagged frame, hence, it can be
handled inside the switch as a member of the same VID group. Set "None" for those tagged frames, usually
this port is now connected to a tag-device.
5. Egress Tag enabled
When Egress Tag is enabled, then, the tag will be added into egress frames and then sent out to the device
that supports tagged-VLAN. When this is disabled, tag will not be added into egress frame and then sent to
device that does not support tagged-VLAN.
AirLive Ether-GSH8TW v2 / 8TW+v2 User’s Manual
13
