AirLive
ARM-104_v3
ADSL2/2+ Router
135
5.
I
forgot or lost my Administrator Password.
Ans.
Reset
the
ARM-104_v3
ADSL2/2+ Router
to factory default by pressing the
“Reset”
button for 10
seconds.
If you are still getting prompted for a password when saving settings:
1.
A
ccess the Router’s web interface by going to
http://192.1681.1.
2. Enter the default
“username”
and
“password”
then click
“Enter”
to log in.
3. Click
on
“TOOLS”
then click “
User Management”
.
4. Enter a new
“Password”
and
new
“Username”
in the
“Username”
and “
Password”
field, and
enter the same password in the second field to confirm the password.
5. Click
“Apply”
after your setting.
6.
I need to upgrade the Firmware.
Ans.
Check your local dealer for technical support. Before proceed the upgrading process, check the
following details:
1. Download the latest Firmware and save at your pointed location.
2. Read the firmware release note carefully before proceed the upgrading process.
3. Refer
to
TOOLS
→
Update Gateway
section for the upgrading process.
7.
Testing LAN path to your ARM-104_v3 ADSL2/2+ Router.
Ans.
To verify whether the LAN path from your PC to your
ARM-104_v3
ADSL2/2+ Router is properly
connected, you can
“Ping”
the
ARM-104_v3
ADSL2/2+ Router with the following procedures:
1. From the Windows toolbar, click
“Start”
and select
“Run”.
2. In the open field, type
“Ping 192.168.1.1”
and click
“OK”
3. If the path is working, you should see the message in the following format:
Reply from 192.168.1.1 bytes = 32 time < 10ms TTL = 60
4. If the path is not working, you should see the following message:
Request timed out
If the path is not functioning correctly:
1. Make sure the LAN port LED indicator is on.
2. Check whether you are using the correct LAN cable.
3. Check your Ethernet Adaptor installation and configurations.
4. Verify that the IP address for your
ARM-104_v3
ADSL2/2+ Router and your workstation are
correct and that the addresses are on the same subnet.
