AIRLESSCO AllPro Mustang 2400, Operation Manual

Page: 15 / 34

Setup
3A0994E 15
Tip Selection
Selecting Tip Hole Size
Tips come in a variety of hole sizes for spraying a range
of fluids. Your sprayer includes an 0.015 in (0.38 mm) tip
for use in most spraying applications. Use the following
table to determine the range of recommended tip hole
sizes for each fluid type. If you need a tip other than the
one supplied, see the Reversible Tip Selection Chart
on page 16.
HINTS:
• As you spray, the tip wears and enlarges. Starting
with a tip hole size smaller than the maximum will
allow you to spray within the rated flow capacity of
the sprayer.
• Maximum tip hole sizes supported by the sprayer:
– SP200, Mustang 2400: 0.015 in. (0.38 mm)
– SP300, Mustang 3100: 0.017 in. (0.43 mm)
Choosing the Correct Tip
Consider coating and surface to be sprayed. Make sure
you use best tip hole size for that coating and best fan
width for that surface.
Tip Hole Size
Tip hole size controls flow rate - the amount of paint that
comes out of the gun.
HINTS:
• Use larger tip hole sizes with thicker coatings and
smaller tip hole sizes with thinner coatings.
• Maximum tip hole sizes supported by sprayer:
–
SP200, Mustang 2400: 0.015 in. (0.38 mm)
– SP300, Mustang 3100: 0.017 in. (0.43 mm)
• Tips wear with use and need periodic replacement.
Fan Width
Fan width is the size of the spray pattern, which deter-
mines the area covered with each stroke. Narrower fans
deliver a thicker coat, and wider fans deliver a thinner
coat.
HINTS:
• Select a fan width best suited to the surface being
sprayed.
• Wider fans allow provide better coverage on broad,
open surfaces.
• Narrower fans provide better control on small, con-
fined surfaces.
Coatings
Tip Hole Size
Stains Enamels Primers Interior Paints Exterior Paints
0.011 in. (0.28 mm)
✔
0.013 in. (0.33 mm)
✔ ✔ ✔ ✔
0.015 in. (0.38 mm)
✔ ✔ ✔ ✔
0.017 in. (0.43 mm)
✔ ✔ ✔