19
USING THE REMOTE CONTROL
Use the Remote Control to:
The
infrared
receiver
of the Airgle
®
panel. In order to get the best signal
transmission,
the
remote
control should be pointed at the
The art of purification
®
Power: Switch the system on/off.
Mode: Change the mode to Auto or Sleep.
Press the Mode button
. and you can turn
on/off the UV lamp for AG600S if held down
for five seconds.
Speed: Regulate fan speed from 1 to 5.
Timer: Set Timer from 1 to 12 hours.
1.
2 .
3.
4.
control panel when pressing any button on the remote.
Note
：
If there are barriers between the remote and the machine, the receiver may not be able to
receive the signal. The remote control is pre-loaded with a battery. Please remove the insulation
film on the battery before use.
Replacing the Remote Control Battery
1. Open the battery compartment by pressing the small lever to the side and slide the battery
compartment out.
2. Remove the used battery.
3. Insert the new battery (3V battery CR2032). Be sure that the (+) and (-) are in the correct
positions.
Remote Control Maintenance
1. Replace the battery if it cannot get a signal.
2. Be sure the same model battery is replaced.
3. Always put the used battery in a bag before disposal.
4. Keep the battery away from children.
s
ystem
is located in the
right-
hand
bottom
corner of the control
2
3
1
2
3
4
Remote Control
