The art of purification
®
1. Timer: Press this button to set the timer for up to 12 hours of continuous operation. The time
shows on the bottom right of the LCD display on the left-hand side of the panel. Timer button
operation is as follows: The machine will run for one hour if the timer button is pressed once and the
LCD displays 01:00; the machine runs for 2 hours if the timer button is pressed twice and the LCD
displays 02:00, and so on up to 12 hours. The machine allows you to access the control settings if the
Timer button is pressed and held for five or more seconds. Please refer to the Control Settings on
page 17 for details.
2. Mode: When you press the Mode button for AG600S, the unit will automatically change to the
optimum speed needed for air purification of the room and change the Air Quality light bar according to
current air quality. The sensor (located on the side of the unit) will tell the unit when to raise or lower
the fan speed depending on the amount of particles in the room.
Sleep Mode: When you use AG600S, Press the Mode button twice successively and the machine will
start sleep MODE. The machine will turn off all lights (including LCD & UV lamp) and change the fan
speed to “1.” Press the Mode button and hold down for five or more seconds to set the UV lamp
On/Off setting (refer to page 17 for details). Press the Mode button again to turn the light and LCD
back on.
3. Reset: Press this button after you have replaced any of the filters or Titanium Pro
®
. This will reset
any blinking lights and set the filter life to full.
Note: This function is only activated when any of the filters requires changing. If the filter life is full,
the button is disabled to prevent accidental pressing of the button.
Control Panel Details: Right-hand side
1617
IR
1
2
3
4
5
Mode
AG600S Control Panel
