AIRFORCE F96 53 S4, Instruction On Mounting And Use Manual

Page: 18 / 28

1 4
Consult the designs in the front pages referenced in the text
by alphabet letters.
Closely follow the instructions set out
in this manual. All responsibility,for any eventual
inconveniences, damages or fires caused by not complying
with the instructions in this manual, is declined.
Use
The cooker hood is provided with an upper air exit B for
discharging fumes externally for models including chimney
flue
C ( Suction Version A- exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the
recirculating version
F : the installation of 1 active charcoal filter F allows the
recirculation of fumes and vapours through the upper grid G .
Electrical connection
The electrical tension must correspond to the tension noted on
the label placed inside the cooker hood. Place a standards
approved bipolar switch with an aperture distance of not less
than 3mm (accessible) from he contacts.
Operation
INSTRUCTION ON MOUNTING AND USE GB
a. ON/OFF lighting
b. OFF motors
1 - 2 - 3. Minimum suction power ( 1 ), medium ( 2 ),
maximum ( 3 ).
You can make the 1 - 2 - 3. speed function for 5
minutes, after which the hood switches off.
To use this function, after having pressed the key to
choose the desired speed, press again.
Use the high suction speed in cases of concentrated
kitchen vapours. It is recommended that the cooker
hood suction is switched on for 5 minutes prior to
cooking and to leave in operation during cooking and
for another 15 minutes approximately after terminating
cooking.
1: + motor
2: On/Off motor
3: - motor
4: On/Off light
5: Led
a
b
1
2
3
2
1
5
4
3
4
3 2
1
Operation TLC
Operation S4
Maintenance
Prior to any maintenance operation ensure that the cooker hood
is disconnected from the electrical outlet.
Cleaning:
The cooker hood should be cleaned regularly internally and
externally.For cleaning use a cloth moistened with denatured
alcohol or neutral liquid detergents. Avoid abrasive detergents.
Warning: Failure to carry out the basic standards of the cleaning
of the cooker hood and replacement of the filters may cause fire
risks. Therefore we recommend observing these instructions.
Anti-grease Filter – must be cleaned once a month, with non
abrasive detergents, by hand or in dishwasher on low temperature
and short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
Charcoal Filter - (only for filter version):
The active charcoal filters F are not washable nor regenerative.
It should be changed every 6 months in normal use.
The active charcoal filters capture unpleasant cooking odours.
Replacing lightbulbs
Warning!
Prior to touching the light bulbs ensure they are cooled
down.
.
Open the light cover by pressing with a finger the part marked
„ p u s h “ .
Replace the dead bulb.
Use only a halogen bulb of 20W max (G4), taking care not to
touch it with naked hands.
Close the light cover.
LED LIGHT
If the lighting group LED does not work, please contact the
technical service center in order to replace the whole
group.
Light key: Lights ON/OFF.
Key 1: activates the motor at level-one suction power;
press key 1 to turn it off.
Key 2: activates the motor at level-two suction power;
press key 2 to turn it off.
Key 3: activates the motor at level-three suction power;
press key 3 to turn it off.
Key 4: activates the motor at level-four suction power;
press key 4 to turn it off.
To turn off the motor, the suction power keys must be in their
original position.
Note: The LED on the hood indicates the different speeds:
green 1st speed, orange 2nd speed, red 3rd speed and
blinking red 4th speed.