4/21/03
Flush Wall Mount
90-100xxx-000
Airespace Access Point Quick Installation Guide
11
Flush Wall Mount
Flush Wall Mount
When you are mounting the AP against a wall (flat side toward the inside of
the building), use the flush-mount bracket.
•
Before proceeding, gently screw the two factory-supplied screws and
spring washers into the bottom of the Airespace AP. Make sure the
spring washers have their convex (high center sections) pointing
toward the screw heads.
Note:
The Airspace AP threaded holes have precision-depth threads. Do
not overtighten the screws, or the bracket will not fit under the screw
heads.
Figure -
Assembling the Mounting Screws and Spring Washers to the Airespace AP
•
Copy the MAC address(es) from the label(s) on the AP onto the corre-
sponding location on the map. MAC addresses have the format
000B85xxxxxx.
•
You have already attached the flush-mount bracket to the wall in
Step 2: Preparing Mounting Locations
.
Slide the screws into the keyhole slots on the mounting bracket as
shown in the following figure.
Note:
Make sure the side of the AP with the door is facing away from
the wall. This ensures that the correct antenna is facing the building,
and makes future upgrades easier.
Note:
If the screws do not securely hold the bracket, remove the AP
and adjust the screws until they securely hold the bracket.
