4
w
w
w
.
a
i
r
c
y
c
l
e
r
.
c
o
m
INSTALLATION INSTRUCTIONS
1.0 CONTROLLER LOCATION
The AirCycler® can be installed anywhere in your home. It can be installed near a thermostat or out of view on/near the
air handler unit. The wiring configuration is flexible.
Warning: Before installing the AirCycler®, turn off all power to the furnace. There may be more than one power to dis
-
connect. Electrical shock can cause injury or death.
2.0 INSTALLING THE AIRCYCLER
®
1. Remove the AirCycler® cover from wall plate
(mounting base) to expose mounting holes.
(Figure 3)
2. Route wires through large hole in the mount
-
ing base. Mount base against wall and mark
wall through 3 mounting holes.
3. Drill 3 - 3/16-in. pilot holes in wall where
marked.
4. Secure mounting base to wall with 3 screws
(provided), making sure all wires extend
through hole in mounting base.
5. Adjust length and routing of each wire to
reach proper terminal and connector block on
mounting base with 1/4 in. of extra wire. Strip
only 1/4 in. of insulation from each wire to
prevent adjacent wires from shorting together
when connected.
6. Connect wires to proper terminals of the con
-
nector block. (Figure 3) Both (R) and (C) must
be connected for proper operation.
7. Improper wiring or installation may damage the controller. Check
to make sure wiring is correct before proceeding with installa
-
tion or turning on the unit.
8. Push any excess wire into wall and against mounting base.
9. Snap cover onto base, making sure pins align with sockets in
connector.
10. Once powered on, the AirCycler® will automatically enter into
operating mode.
3.0 CONFIGURATION
The three keys on the exterior of the AirCycler® are used to
configure the AirCycler®. (Figure 5)
The AirCycler® FRV has four settings.
Factory default settings: FAN OFF - 20 minutes; FAN ON - 10 minutes; VENT ON - 10 minutes; VENT OFF - 20 minutes
Figure 3
