NOTES ON LOCATION:
In order to get the most effective use from your humidifier, it is important to position
the unit where the most humidity is needed or where the moist air will be circulated
throughout the house such as near a cold air return. If the unit is positioned close to
a window, condensation may form on the window pane. If this occurs the unit
should be repositioned in another location.
Place humidifier on a flat level surface. Do
NOT position the unit directly in front of a hot
air duct or radiator. Do NOT place on soft
carpet. Due to release of cool, moist air from
the humidifier, it is best to direct air away from
thermostat and hot air registers. Position
humidifier next to an inside wall on a level
place at least 2 inches away from the wall or
curtains.
Be sure that the humidistat, which is located
on the power cord, is free from obstruction
and away from any hot air source.
Locate nearest 120V A.C. wall socket in the location desired, preferably on inside
wall. With the humidifier in the desired location, route the electrical cord safely so no
one will trip or upset the humidifier. Plug unit in.
After the humidifier is positioned where it will be operating you are ready to fill the
humidifier.
ASSEMBLY
1) Unpack humidifier from carton. Remove all packaging materials.
CASTERS
2) Lift chassis off of base and set aside. Remove the parts bag, wick/ wick
retainer and float from base.
3) Turn the empty base upside down. Insert each caster stem into a caster hole on
each corner of the humidifier bottom. The casters should fit snugly and be
inserted until the stem shoulder reaches the cabinet surface. Turn the base right
side up.
FLOAT
4) Install float by separating the two
flexible halves of retainer clip,
inserting the float into the clip and
securing it into the base.
EVAPORATIVE WICK
5) Ensure the 1043 Superwick is
installed in the two-part wick retainer
base in the base of the humidifier
6) Position the chassis over the base
frame and press it onto the base
firmly until it is in place.
CAUTION:
Ensure the chassis is placed
on the base with the float facing forward
to prevent damage to components.
4
