AIR TORQUE
Manual for assembly of square position ‘diagonal’ in ‘parallel’
The standard versions of the AT-actuators have the square position ‘diagonal’.
Note:
Pay attention to the maintenance informations for all assemblings.
Position of the square ‘diagonal’ (standard)
First remove the end caps and the spring cartridges (only type S).
Continue with unscrewing the external stroke adjustment for the open
position (90°, left screw).
Then move the pistons outside the body
through turning of the drive shaft.
Position of the square ‘parallel’
Turn back the drive shaft into the basic position (until the end position of the right adjustment screw
is touched, closed position). Remove the indicator and the spring clip. Then push down the drive
shaft a little, while fixing the cam in it’s position.
cam drive shaft), until the
Turn the drive shaft for one tooth (connection
square is parallel.
Now fit the drive shaft again.
After that turn the drive shaft in the open
position (see above) and
assemble the actuator.
Note: only unscrew left adjustment
screw
Note: adjust left screw at last.
Position of the square ‘diagonal’.
Square position ‘parallel’.
Attention: Fix cam in the endposition
during removing the drive shaft!
Via Alla Campagna n.1 * I - 24060 Costa di Mezzate (BG)
Phone: 0039-035-682299 * Fax: 0039-035-687791
e-mail: [email protected] * http://www.airtorque.it
Modifications reserved. Date 01.2005.
No guarantee for accuracy.
Older data sheets are invalid.
Assembly diagonal/parallel
0911e
Manual for Assembly
Diagonal in parallel
AT 51 - 801
