AIR TORQUE
AIR TORQUE
AIR TORQUE
The 4th Generation
Maintenance
When all component are disassembled, those not being replaced
should be properly cleaned and inspected for wear prior to being
greased and reassembled.
6.3) Assembly :
Prior to assembly, ensure all components are perfectly clean and free
from damage. Please see point 3 for recommended lubricants.
A) Drive shaft assembly (Part No. 60), figures 06 and 07:
•Install top and bottom pinion bearings (06) and (07) and top and bottom
pinion O-rings (21) and (22) onto the shaft.
•Grease the outside surface of the drive shaft on
top and bottom as shown in figure 06.
•Insert partially the drive shaft (60) in the body (50),
install octi–cam (01) in the correct position as
shown in figure 07 related to the bottom and top
of the drive shaft and the rotation of the actu-
ator when energised and install internal thrust
bearing (08). Insert completely the drive shaft in
the body.
•Fit external thrust bearing (08), thrust washer (10)
and then external circlip (18) using snap ring pliers.
B) Pistons assembly (Part No. 40), figures 08, 09, 10 and 11:
•Install piston O-rings (16), the Piston skirt (05) and piston head (15) bear-
ings.
•Grease the internal surface of the body (50) and the piston (40) rack
teeth.
•Hold the body (50) in a horizontal position by inserting the top of the shaft
into a vice or the bottom of the shaft connection into a male drive fitted
in a vice as shown in figure 08.
• Ensure that the octi-cam is in the right position as shown in figure 09.
•For standard rotation assembly (clockwise to close) rotate the body (50)
about 40-45° counter-clockwise from bottom view or clockwise from top
view depending on which way the shaft has been linked as shown in
figure 10.
•Press the two pistons (40) simultaneously inside the body (50) until the pis-
tons are engaged and rotate the body clockwise from bottom view or
counter clockwise from top view until the stroke is completed.
•Ensure that when the pistons are inserted that they both mesh at the
same time. Check fully closed and open positions as shown in figure 11.
Via Alla Campagna n.1 * I - 24060 Costa di Mezzate (BG)
Phone: 0039-035-682299 * Fax: 0039-035-687791
e-mail: [email protected] * http://www.airtorque.it
Modifications reserved. Date 02.2000.
No guarantee for accuracy.
Older data sheets are invalid.
Maintenance
908e
