10
MAINTENANCE
QUARTERLY - CLEAN WITH FORMULA 2000 Plus
Clean the Peri-Pro III Transport with Formula 2000 Plus quarterly or
whenever a black residue is evident on the transport or in the tanks.
Use the Peri-Pro Transport Cleaning Kit (PN 43975)
Each kit contains:
Cleaning
tub
Brush and cleaning sponges
Twin pack of Formula 2000
Plus
CAUTION:
Use cold water only.
6. Sprinkle two powder packets of Component 2 evenly across the cleaning tub. Formula 2000
Plus’s effervescent cleaning action will begin as soon as Component 2 is added. Some odor
and vapor will be evident.
7. Soak the transport for approximately 30 minutes, or until the effervescent action stops.
8. Remove the transport and, under cold running water, remove any remaining deposits with the
brush; rinse.
9. Dispose of the cleaning solution in accordance with local codes. Rinse the cleaning tub and
place the transport back in the tub. Fill with fresh water and drain. Rinse and drain at least 2
more times. (Be sure to rinse thoroughly since cleaner residue can contaminate fresh chemistry.)
10. Place the transport on a towel with the gears facing up and air dry thoroughly. Check that the
shutter area is dry before using. If not, dry with a soft, lint-free towel. See Fig. 14.
11. Change the water. Follow the steps for changing water under Daily Maintenance. If the wash
tank is particularly soiled or slimy, it must be thoroughly cleaned and rinsed. After cleaning, if
the tank was removed.
Figure 13
Figure 14
CAUTION:
Use in a well ventilated area. Wear protective clothing, rubber
gloves and goggles. Review the Material Safety Data Sheet
that comes with every Formula 2000 Plus Twin Pack.
1. Turn the
POWER OFF
and unplug the line cord. Remove the
film receptacle; lift the cover off.
2. Remove the transport and rinse under running water.
3. Place the transport into the cleaning tub with the gears facing
up .
4. Pour two bottles of Formula 2000 Plus Component 1 into the
cleaning tub. Pour slowly. Do not splash or splatter solution -
wipe up any spills. (Use both bottles of Formula 2000 Plus in
the Twin Pack to insure adequate cleaning of the transport.)
5. Add cold water to the recessed line in the tub.
12. Clean the Dryer Transport if dry, white chemistry residue is evident on
the rollers.
Remove the screw holding the dryer front cover plate in place.
Slide the cover plate up, remove it and lift the dryer transport
straight up and out.
Use warm water and a brush to remove the residue; rinse and
completely air dry.
Reinstall the dryer transport and the cover plate.
Important:
This plate is necessary for proper film drying.
13. Change the chemistry. Follow the steps for changing chemistry under Every Two Weeks
Maintenance.
14. Reinstall the transport and reassemble the Peri-Pro III. Follow the steps for reassembly under
Every Two Weeks Maintenance.
