Initial Steps
STEP 6
Unlatch & open the front lid
completely. Gas struts are fitted
to aid the process and support
the weight of the lid at this
stage. Secure the front lid to
the front support rack (stone
guard frame) with the over-
centre latch and retaining pin.
STEP 7
Repeat the process with the
rear lid and fit the two rear bed
support legs into place. Ensure
that the D-pin clips are fully
secured on the rear bed end
section by inserting them
through the holes and securing
them with the clip.
STEP 8
Walk around the Air OPUS
®
and inspect the tent to ensure that the canvas is properly located within
the aluminium channels and that no part of the tent is caught or snagged.
SETTING UP YOUR Air OPUS
®
CAMPER
opuscamper.com.au
13
TENT INFLATION TECHNOLOGY
STEP 10
Ensure the main internal air valve is open (vertical/in line). Tighten all external air valves on each air
beam (5 on tent and 7 on annexe).
STEP 11
Turn the power key ON. Turn the pump master switch ON. Push the pump button and watch your
camper inflate!
STEP 12
One pump shuts off, CLOSE the main internal valve to lock off air system. You may also wish to
close some cross linking valves to retain constant pressure over an extended stay.
STEP 9
Fit each corner of the canvas over the corner of each bed tray.
The seam on the canvas should line up with each corner of the
bed lid. If your camper is fitted with corner straps, secure to
hook. Make sure that the door is zipped (closed) before inflation.