5. Configuration
AirLive FE-201DM User’s Manual
38
From the “Motion”
tabbed pane, you can define specific target areas within the scope of
surveillance to focus the motion detection function.
Defining multiple motion detection areas
:
1) Enable the “Enable Motion Detection” check box.
2) Click “Add” button and a default frame will pop-up on the screen.
3) Click and hold inside the frame to drag it to the location where you want to
focus detection. Resize the frame by dragging its corners or borders.
4) To assign unique names to each framed location for easy identification,
click on the frame and a “Window Name” text box with the default name of
the selected frame, will appear at the bottom of the pane (see figure below).
Enter a new name and click the “Save” button. Wait for a while for the
change to take effect.
5) To delete a frame that is no longer needed but was previously saved, click
on the unwanted frame and click “Delete” button. The frame will disappear
after a while.
6) To delete multiple frames that are not yet saved, directly click the “Refresh”
button instead of deleting them individually. The “Refresh” button will
automatically clears all unsaved frames.
.
※
Total defined motion detection areas cannot exceed 10 frames.
2. Video
The Video
tabbed pane sets the video recording trigger method to use when motion is
detected by the Camera. The four methods available for selection are Period, Schedule,
Motion, and GPIO Input, each of which can be set up with user scheduled recoding time
and duration, as well as defining the video record file target destination.
•
Period: This method will trigger the Camera video surveillance/recording
operation for a defined Time Lapse (in seconds) whenever motion is detected.
The video record may be provided to host by E-mail/FTP, stored in the SD card,
Remote Disk as selected or through all of them.
