LoadLifter 5000 Series
MN-1052
7
8. Thread the nylon lock nut on the M8 bolt only enough to allow the bolt to slide freely
in the slot. This will allow you to align the frame bracket correctly.
9. Set the frame bracket (with the socket head bolt in it), on the frame, with the flange
pointing up. Insert the socket head bolt line up tool into the existing hole in the frame
that was under the stock jounce bumper (Fig. 10).
10. The bracket should sit flush to the bottom of the frame. If there is any leftover weld
holding the bracket off the frame, remove and grind down so the bracket is flush.
11. With the socket head bolt in the hole, push the flange against the side of the frame
(Fig. 11) and mark the existing hole under the frame with a paint marker (Fig. 12).
The socket head bolt remains in place but requires no additional tightening.
If possible, with the bracket in position, use a 21/64” (or closest) centering punch to fit
into the hole and center-punch the frame for an exact center of the hole.
fig. 10
fig. 11
M
fig. 12
NOTE
NOTE