Air 802 AP-G300, User Manual

Page: 8 / 98

Hardware Installation
Once you check off everything from the package, you can start to install the
AP-G300. You can mount to a pipe, a pole or to the side of a building. The
steps are showed in the following
：
1. You must mount the AP-G300 into the bracket first.
2. You can use the 2.5 inches U bolt to mount on the pipe. The two U bolts
must be mounted tightly. Be aware of not over-tighten the U bolt.
3. After checking the AP-G300 is mounted well, you can connect the following
Steps Pictures
two cables: the RJ-45 network cable to Ethernet port of AP-G300 and the
RF cable to antenna port. The RJ-45 network connects steps are showing
as below:
Mounting picture
7