7
From the top menu, select
Connection
and click Association Settings
. Here, stations created in the previous
steps will be associated to stations found on the network. Select a station from the
Station Settings List and
one from the Station List
below. Clicking
Apply
will assign the Station Name and IP Address to the station,
and that station will quickly reboot.
Association Settings
Scroll down to confirm the stations were successfully associated. If the wrong station information was
associated to a station, select that station on this list and click
Remove Association
. Once removed, scroll
up and associate the station correctly.
Typically, stations deployed
across a managed network
cannot be found by Support
Tool unless the network
is configured to allow this
broadcast search. In this case,
it may be easier to move the
stations to a switch local to the
programming PC than it would
be to configure the network
to allow a network-wide
broadcast.
If a Station Search fails immediately, go to
File
from the top menu and select
IXG Support Tool Settings
. Find the Select
NIC drop-down and select the correct NIC Support Tool should use, and click
Okay
. Return to Association Settings to
try again. If the Station Search continues to fail immediately, a local antivirus or firewall may be preventing this action.
Disabling one or both of these may be a simple solution in quickly finishing the initial system configuration.
Associated Station List
