8
A. After putting the cleaning into your pool, it will start to detect/
calculate the pool size with Initial Cross Route & Floor Cross Route.
Please note that the detection time depends on the pool size.
B. The cleaner will start wall climbing and waterline scrubbing for
about 15 minutes with Climbing Route.
C. It goes to floor cleaning mode (Floor Route) which is a full cleaning
cycle and takes around 35 minutes. Please note that the cleaning
time depends on the pool size.
D. It turns to wall climbing and waterline scrubbing mode again for
around 15 minutes.
After the cycles above are completed, and if the battery is still alive,
it will repeat C and B until the battery drains out. The cleaner will not
climb walls if the battery level is under 15%.
4.3 General Cleaning Time/Modes
4.4 Installation of Floating Blocks
1.
2.
Tear off the protective film on
the back of the floater and stick
one by one according to the
position shown in the figure
Open the filter cover and pick
up the filter basket
NOTE: Please intall the foams only if your cleaner can’t cover most
areas and it has issues with wall climbing.
