Aimco AAP1B66400A, Operation Manual

Page: 6 / 12

ENSURE THAT THE ACRADYNE HT PNEUMATIC NUTRUNNER
IS DISCONNECTED FROM THE AIR SUPPLY.
• Orient the Reaction Bar so that the recess above the spline
on the Reaction Bar is oriented towards the rear of the tool
and any reaction foot is oriented away from the tool anvil
• Install the Reaction Bar onto the splines of the gearbox
ensuring that the Reaction Bar is staying true to the
splines
• Install the Reaction Bar retaining ring/plate onto the end
of the Gearbox securing the Reaction Bar in place on
the Gearbox
FAILURE TO SECURE THE REACTION BAR
PROPERLY CAN RESULT IN SEVERE INJURY TO THE
OPERATOR AND/OR DAMAGE TO THE TOOL/APPLICATION.
• Reconnect the AcraDyne HT Series Pneumatic Nutrunner to air supply
•
Ensure that the workpiece is securely fixed.
THE TOOL HANDLE MUST NOT BE LOCATED AGAINST AN OBJECT OR RESTRICTION DURING OPERATION OF THE TOOL TO AVOID
CREATION OF A PINCH POINT. AN OEM SOURCED OR APPROVED REACTION BAR OR PROPER REACTION ABSORPTION DEVICE MUST BE
IN USE AND IN GOOD CONDITION ANY TIME THE TOOL IS OPERATED. PROPER TORQUE REACTION MANAGEMENT PRACTICES MUST BE
OBSERVED AT ALL TIMES. FAILURE TO UNDERSTAND AND EMPLOY SAFE OPERATING TECHNIQUES CAN RESULT IN TOOL DAMAGE, APPLICATION
DAMAGE, SEVERE PERSONAL INJURY, OR DEATH
When ready to begin tightening:
• Swivel the reaction bar (Slip Ring Equipped Models only) into position minimizing or ideally eliminating any gap between
the Reaction Bar and the Reaction Surface of the application On Fixed Gearcase models, ensure that reaction absorption
device is configured properly.
• Complete the tightening event
A complete tool system consists of the following items:
AFRL-4HTA
(Maximum allowable Input
Pressure not to exceed 120 PSI)
Air Hose Tool Reaction Bar
Operation
Installing Reaction Bar
Reaction Bar
Retaining Ring
Gear Box