Aimco AAP1B66400A, Operation Manual

Page: 3 / 12

Introduction
Safety Information
Thank you for your purchase of an AcraDyne® HT Series Pneumatic Nutrunner These Nutrunners offer a reliable and
dependable solution for the installation and removal of heavy-duty fasteners in a variety of industries that require high torque
capability, accuracy, power and safety
1) WORK AREA
a Keep work area clean and well lit Cluttered and dark
areas invite accidents
b Do not operate power tools in explosive atmospheres,
such as the presence of flammable liquids, gases or
dust Power tools create sparks which may ignite
the dust or fumes Ensure there are no cables or gas
pipes that may cause a hazard if damaged by the tool
c Keep children and bystanders away while operating a
power tool Distractions can cause you to lose control
d Be aware of trip hazards such as air lines and
electrical cords in the work area
3) PERSONAL SAFETY
a Only qualified and trained operators should install and
adjust tool
b Stay alert, watch what you are doing and use common
sense when operating a power tool Do not use a
power tool while you are tired or under the influence
of drugs, alcohol or medication A moment of
inattention while operating power tools may result in
serious personal injury
c Use safety equipment Always wear eye protection
Safety equipment such as dust mask, non-skid
safety shoes, hard hat, or hearing protection used for
appropriate conditions will reduce personal injuries
If the maximum duty cycle of the attached tool is
exceeded or the tool temperature exceeds 50° C ,
then the operator should wear protective hand wear
(gloves)
d Avoid accidental starting Ensure the switch is in the
off-position before plugging in Carrying power tools
with your finger on the switch or plugging in power
tools that have the switch on invites accidents
e Remove any adjusting key or wrench before turning
the power tool on A wrench or a key left attached to a
rotating part of the power tool may result in personal
injury
f Do not overreach Keep proper footing and balance
at all times This enables better control of the power
tool in unexpected situations
g Dress properly Do not wear loose clothing or jewelry
Keep your hair, clothing and gloves away from moving
parts Loose clothes, jewelry or long hair can be
caught in moving parts
h If devices are provided for the connection of dust
extraction and collection facilities, ensure these are
connected and properly used Use of these devices
can reduce dust-related hazards
i Ensure hose and fittings are securely fastened to
prevent injury from disconnected whipping hose
Whenever universal twist coupllings are used, lock
pins should be installed and whip check safety cable
shall be used
j Always shut-off air supply, drain air hose pressure
and disconnect tool from air supply when not in use,
before making changes to accessories or when in
repair Air under pressure can cause severe injury
k Do not modify tool. Any modification of tool could
result in personal injury
l Failure of the workpiece, tool or accessories can
generate high velocity projectiles
4) POWER TOOL USE AND CARE
a Do not force the power tool Use the correct power
tool for your application The correct power tool will
do the job better and safer at the rate for which it was
designed Hold tool with a light, safe grip
b Do not use the power tool if the switch does not turn
it on and off Any power tool that cannot be controlled
with the switch is dangerous and must be repaired
c Tool is intended for the use on threaded fasteners with
impact grade sockets All sockets and extensions should
be secured with pins and o-ring to the tool Any other
use of this tool is strictly forbidden
d Inspect tool to ensure all markings are visible and legible
e Operator and maintenance personnel should physically
be able to handle the bulk, weight, and power of the tool
If not, the use of a balancer is recommended
f Should the operator experience discomfort or pain in
the hands, arm or shoulders, do not ignore it and seek
the advice of a qualified medical professional.
CAUTION – Do not use the Acradyne® HT nutrunning system without fully reading this manual and having a complete
understanding of the correct usage of a high torque-delivering tool and any associated reaction bars/accessories.
SAVE THESE INSTRUCTIONS