5
6.
Adjust camera bracket to proper angle and mount cam-
era to camera bracket. See FFiiggu
urre
e 5
5.
FFiiggu
urre
e 5
5
7.
Assemble dome in the trim ring by lining the slots in the
dome with tabs in the trim ring. Push one side of the
dome under the tab; the other side should clear the
other tab. Now turn the dome to secure it.
8.
Attach the dome/trim ring by lining up the dots on the
box and the trim ring. Push on one side of the trim ring
near the the flat section of the box, then push on the
other side of the trim ring until it snaps into place. Listen
for a distinct click to ensure ring is securely in place. See
FFiiggu
urre
e 6
6.
FFiiggu
urre
e 6
6
9.
Adjust the dome so that the viewing slot is in the proper
position
5
MAINTENANCE
No special maintenance is required.
If internal wiping is necessary, use only microwave type paper
towels, or equivalent soft paper towels. Roll a section into a
tightly wound tube, tear tube in half, and wet the fuzzy torn
end with a solution of isopropyl alcohol diluted with water.
While holding the dome with its opening facing down, wipe
the interior using a circular motion spiraling in toward the
center. Use a new paper towel for each two passes.
To clean the exterior of the dome, use any nonabrasive
cleaning cloth and cleaning agent that is safe for use on acrylic
plastic. Liquid or spray cleaner/wax suitable for use on fine
furniture is acceptable.
4.2 Hard Ceiling Mounting
Mount the unit in a hard ceiling, e.g. dry wall etc. as follows.
Be sure the ceiling will support the weight of the housing and
camera.
1.
Cut a 172 mm (6.75 in) diameter hole in the ceiling. Use
two pencils (or a pencil and a nail) with the template tool
provided to draw the circle.
2.
Run the electrical cable into the housing through the con-
duit and the hole in ceiling as required by the applicable
codes.
3.
Install box into pre-cut hole with the bottom flange
pressing against the ceiling. Position the round section of
the box in the direction that the camera will be aimed.
See FFiiggu
urre
e 4
4.
FFiiggu
urre
e 4
4
4.
Pull the drawstring tight (away from the screw) and
lock into the groove. D
DO
O N
NO
OT
T C
CU
UT
T D
DR
RA
AW
W--
SS T
T R
R II N
N G
G Push the excess string through the hole
provided. As an option, a screwdriver may be used
to turn screws and lock ceiling clamps in place.
5.
Complete the electrical connections.
FFiiggu
urre
e 3
3
13. Adjust the dome so that the viewing slot is in the proper
position.
14. Replace any previously removed adjacent tiles.
