ATTACHING AND ADJUSTING THE FEET (CONTINUED)
6. Place the blue swivel disc into the hole in the middle of the bathboard. Whilst holding in
place, use the circular bolt to secure in place from the bottom. Ensure you tighten until
it is secured in place, but can still rotate. Do not over tighten, as the disc will not swivel.
FITTING AND ADJUSTING THE BATH BOARD
1. Turn the board over with the feet facing up.
2. Loosen off the feet holding the plastic fixing screw in position.
3. Turn the board over so that the feet are facing down.
4. Place the board over the bath traversing its width.
5. Reach underneath the board and push both sets of feet outwards evenly until they are
gripping the wall of the bath.
6. Tighten off the plastic fixing screws. N.B. It is only necessary to tighten the fixing screws
finger tight.
7. Do not over tighten them as this can cause damage to the thread and cause the
product to fail.
8. Double check the feet are friction tight to the wall of the bath before use.
Always check the tightness of the board before each use
Always repeat the installation every time the board is removed
