ATTACHING THE HANDLE
1. Insert the two ends of the blue
handle into the circular holes
at one end of the bath board.
Insert the handle, which is slightly
curved to one side, so that the top
of the handle leans in, towards the
middle of the bath board.
2. Using the plastic handle fixing
screws supplied, insert each in
turn into the corresponding hole
on the bottom of the bath board
and, holding the handle on
the top of the bath board, turn
the plastic fixing screws until they
are finger tight only. NB. Do not
use a screwdriver as this may
damage the screws, if required a
large coin may be used carefully
to assist with turning the screws.
ATTACHING AND ADJUSTING THE FEET
1. Turn the bath board over so that the
bottom of the board is facing upwards.
2. Insert each foot into the slot on the
underside of the bath seat.
3. Turn the bath board over so that you can
see the top of the board and locate the
four corresponding slots for each foot.
4. Insert a plastic fixing screw through
the slots into the narrow opening at the
top of each foot and, holding the foot to
prevent it from turning, turn the fixing
screw until it is finger tight only. NB. Do
not use a screwdriver as this may
damage the screws, if required a large
coin may be used carefully to assist with
turning the screws.
5. Repeat for all four feet
