7
5.
6.
Your mats have double-sided adhesive tape
on the mat edges. Stretch the mats and
secure the mats to the floor with the tape.
Where required additional tape can
be used.
Apply glue between the heating wires
(Apply only on the fiberglass net - do not
glue the heating wires).
Place the cold leads of the mats between
the mats toward the junction box. Try to
place the cold leads so that they do not
cross each other.
7.
8.
Important!
Ensure that the cold leads
of the mats do not cross over the mats.
Since the cold lead connector is slightly
thicker than the rest of the mat, create a
slight groove in the insulation board under
the connector to ensure that the heating
mat lays flat. If any cold leads cross, create
a groove for the cold leads at the point at
which they cross.
Mark each pair of cold leads coming from
the same mat with a number. Place a small
sticker with the number of each pair of
leads close to the end of the lead.