SOLUTIONS
|
+49 2173 -164-0
| FREE FAX 0800 / 2 42 32 93 |
|
WWW.AHB-SHOP.COM
SOLUTIONS
|
+49 2173 -164-0
| FREE FAX 0800 / 2 42 32 93 |
|
WWW.AHB-SHOP.COM
5
USER MANUAL
It will automatically turn off if you do not set the lock in alarm condition within 60 seconds.
3. Activating the alarm
If the device is not already switched on please press the “POWER ON” button on the steering
wheel lock to activate the system, a warning tone will sound twice. Press the “LOCK” button
on the remote control, a warning tone will sound once along with a single flash of the LED. The
alarm will be activated after 5 seconds, the LED will flash regularly. If you accidentally trip the
alarm while entering the vehicle, please do not worry. The LED flash pattern will change and 5
warning tones will be heard, If you trip the alarm a 2nd time within 5 seconds, the alarm will
go off for about 30 seconds at full power at about 100 - 120 DB and the LED will be lit up con-
tinuously. If you trip the alarm again within another 5 seconds, it will repeat the above. Simply
press the ”UNLOCK” button on the remote control, a warning tone will be heard twice along
with a single flash of the LED, the alarm is now deactivated.
4. Deactivating the alarm
Simply press the ”UNLOCK” button on the remote control, a warning tone will be heard twice
along with a single flash of the LED, the alarm is now deactivated. If you do not set a new
alarm within 60 seconds, the device will power off
5. Low battery signal on the steering wheel lock
A low battery will be signaled with a warning tone every 15 seconds while the device is pow-
ered off. Please change the batteries in this case, the device will need two 9V batteries.
6. Low battery on the remote control.
Each remote control has two 3V CR2025 button cells.
If the remote stops working please change these button cells.
7. Warning
Always keep a spare key in a safe place and remember where you put it!
CR2025 3V button cell
for the remote control
9V batteries
for the steer-
ing wheel lock
“UNLOCK” Button
“LOCK” Button
Buzzer
“ POWER ON”
Button
Remove these two screws
to change or remove
batteries
LED
