17
To remove the cap, release
the 2 press studs at the front
(1) and the 2 at the back of
the helmet (2). Remove the
cap from the helmet.
NB: Extract the cap only
after releasing all the press
studs to avoid damaging
them and prevent damage
to the fabric parts.
To refit the cap, insert it insi-
de the helmet and clip the 2
press-studs at the back (4)
and the 2 at the front (3) into
place.
To install the throat shield, first insert the front plastic tooth
into the housing on the chin strap and then insert the two side
teeth (1). Check that the throat shield is securely fastened to
the chin strap.
1
2
3
4) RETENTION SYSTEM
There are three types of retention system:
- DD
- Quick release buckle
- Micrometric adjustment buckle
The instructions for the use of all three types are given below.
4.1) DD retention system
To fasten the helmet, slot the
tape through the two rings (1),
pull the end of the tape (2) until
the strap presses against the
jaw and click the anti-flapping
press-stud (3) into place as
shown in the figure.
Check that the helmet fits
snugly (see the paragraph
entitled “Choosing the right
helmet” in the “Safety Warn-
ing” booklet).
To remove the helmet, release
the press-stud by pulling the
end of the tape and loosen
the tape, pulling it through
the rings, using the red tab as
shown in the figure.
