https://www.agrotkindustrial.com/
13
First Time Use Procedure
Before operating the brush cutter, check the skid steer’s hydraulic oil level and add
oil if necessary.
If you are operating the Piston Motor Articulating Cutter (SBCNS) ensure the case
drain hose is properly attached to the prime mover’s case drain connection. DO
NOT operate this attachment WITHOUT the case drain hose attached. Excessive
hydraulic pressure will blow out the seals.
Ensure that hydraulic hoses are securely locked to the skid steer hydraulic couplers
before starting the brush cutter.
After starting skid steer, lift attachment 36 inches off the ground surface:
1. With the skid steer engine RPMs just above idle, activate the skid steer’s auxiliary hydraulic
system.
2. Swing the boom to the right using the skid steer’s auxiliary electrical controller, or by holding
down the RT button on the paddle controller.
3. Tilt the cutter up by holding down the UP button on the paddle controller. Then tilt in the
opposite direction by holding down the DOWN button.
4. Swing the boom to the straightforward position and tilt the cutter to the level position using the
buttons on the paddle controller.
5. Allow the cutter to run for 30 seconds to purge air from the system, then turn off hydraulic flow
to the brush cutter and allow it to come to a complete stop.
6. Lower the brush cutter to the ground, set parking brake, shut off the skid steer’s engine and exit
the operator’s compartment.
7. Check the skid steer’s hydraulic oil level, add oil if necessary
