4
EN
Work modes
The controller can have multiple work modes. These modes are
detailed in the table below. Attention, the work modes are related
exclusively to the output ( and ), and do not affect at all the
accumulator charging process.
To enter the work mode changing menu, press and hold the button
for 3 seconds. After entering the menu, every repeated press of the
button switches to the next mode. After reaching the end of the
possibilities, the first mode comes again. If the button is not touched
for a while, the controller memorizes the selected mode and exits
the menu.
ATTENTION: our company does not recommend using
the output due to the following reasons:
• It becomes highly possible to damage the connected
consumers due to over-voltage, by an accidental disconnec-
tion of the accumulator.
• The accumulator may deplete accidentally due to a wrong
work mode selected.
• It is highly possible to damage the output due to an
overload or short circuit. Although the output is protected for
these situations, the protection is limited for certain situa-
tions and it is not guaranteed to always work as expected.
In the case when you decide to use the output, the table below
enlists the possible work modes. But, by using the output, our
company refuses to offer the 1 year warranty for this device, due
to the extremely high possibility to damage the controller!
Display Work mode
Description
Only charge.
In this mode the output of the controller
is disabled, but the charging control is still
working (as in any other mode).
The controller is being sold set in
this mode.
We recommend using the controller
exclusively in this mode!
...
Automatic
illumination
mode with
delays of hours.
Please pay
attention to
the dot on the
display!
In this mode the controller activates the
output when the environment light
decreases (to turn on the lights), after
a 1...13 hour delay.
means a delay of one hour, means two
hours, nine hours, (zero+dot) 10 hours,
and the last value, (three+dot) 13 hours.
Automatic
lighting with
a delay of
10 seconds.
In this mode the controller activates the
output when the environment light
decreases, after a delay of 10 seconds.
When the environment light gradually
increases, the output is turned off after
a delay of 10 seconds.
The output is
always active.
The output is always activated (except
when the charge level of the accumulator
is low).
Manual mode
( = Hand).
The output’s activated state alternatively
changes on each press of the button
(after the controller returns from the work
mode menu).
Test mode
( = debug).
It is the same as the mode, except there
are no delays before changing output state.
