Agrint ARIETE, Original Use And Maintenance Instructions

Page: 15 / 27

15
4
. K
NIVES SHARPENING, REVERSING OR SUBSTITUTION
a) If you want to check the conditions of both the rotor and
knives, please read the following instructions:
1. Stop the machine.
2. Unscrew the bolts and swing the “CP” component.
3. Check the conditions of the four knives by rolling the
rotor with your hand. If the knives are in good
conditions but need to be sharpened, please
sharpen them as follows:
4. Clean the hole of the screws indicated in the side
figure with the number “2” with a sharp tool.
5. Unscrew the two screws corresponding to the
number “2”.
6. Remove the “CT” knife.
7. Sharpen the knives by using particular machines
that ensure a sharpening angle of 45°.
8. Put the “CT” knife back and tighten the two screws
corresponding to the number “2”.
9. For all the other knives repeat the same procedure
from the point number 4 to the point number 8.
10. Put the “CP” component back to the starting
position, fixing it with the two bolts number “1”.
b)
To turn the knives over, please read the following instructions:
1. Use your hand to roll the rotor so that the knife is within the reach of the user.
2. Clean the hole in the two screws number “2” with a sharp tool.
3. Unscrew the two screws indicated with the number “2”.
4. Remove the “CT” knife.
5. Reverse it by 180° and replace the current knife with another original knife.
6. Put the “CT” back and tighten the two screws number “2”.
7. Repeat the same procedure from the step 2 to the step 6 for the other knives.
8. Put the “CP” component back to the starting position and fix it with the two bolts number “1”.