9
If The Engine Does Not Start
1. If the engine starts but does not continue to run, repeat steps under Cold Starting.
2. If the engine cranks but does not fire, squeeze the throttle lever and repeat steps under
Warm Starting.
CAUTION!
With the throttle lever depressed, the engine will run at a high enough RPM to turn the tines.
This could propel the unit forward. In this case, tilt the unit back onto the stabilizer bar in order
to raise the tines off the ground!
3. If the starter does not make any noise when the button is pushed, either the stop switch isn't
in the "on" position or the batteries need to be charged. Repeat charging steps on p. 8.
4. If your WEEDER is equipped with the optional recoil starter, follow the same steps as above
except pull the recoil starter handle briskly instead of pressing the start button.
5. NOTE: When the engine stalls from lack of fuel, repeat the "Cold Starting" procedures.
Stopping The Engine
(FIG. 11 & 11A) Decrease the engine speed by releasing the throttle lever (1), then turn the stop
switch (2) to the "OFF" position.
USING WEEDER FOR THE FIRST TIME
a) With a firm grip on the handles, squeeze the throttle lever against the hand grip. As the tines
make contact with the ground, hold the unit back so that the tines begin to dig. If the tilling
depth is not correct (too high or too low) the stabilizer bar may be adjusted as follows:
b) Move the STOP switch to the OFF position and remove the spark plug cap. CAUTION: Never
make any adjustments to the stabilizer bar, engine, or tines while the engine is running.
c) Remove the snap pin and clevis pin securing the stabilizer bar (see FIG. 9). Adjust the stabilizer
bar up or down according to the desired depth. NOTE: Move the stabilizer bar up for a more
shallow cut or downward for a deeper cut. Reinstall the clevis pin and secure with the snap pin.
d) Start the engine and recheck the depth.
If the depth is still unsuitable, repeat the above steps.
