3
START UP
1. After the engine starts, run 3-5 minutes at a low speed
2. When the engine is heated enough, adjust the throttle handle to the corresponding speed.
3. Note: don’t accelerate abruptly due to bad lubrication of the engine at the beginning of startup.
4. Avoid the speedy idle motion and over speed motion. If the throttle is totally opened, the
engine will run over speed, which not only shortens the service life of the engine but also
causes more problems in the engine.
1. Reduce the gasoline engine to the slowest speed and run 3-5 mins
2. Press the stop switch to stop the engine.
RUNNING
STOPPING
1. Turn on the gasoline switch until the gasoline flows out the clear plastic pipe. (Fig 3)
2. Close the choke totally (Fig 4)
If the engine is heated, the choke must be totally opened.
3. Open half the throttle.
4. Draw the starter several times slowly, and then draw quickly.
Note: if the excessive gasoline causes the difficult start, take down the ignition plug and the
input pipe, open the choke and the throttle totally, draw the starter several times then install
the input pipe and start the engine. After the startup, open the choke totally.
Fig 3
Fig 4
Open
Close
The Choke Handle
