Two-wheel tractor agria 3600
11
During operation do not leave the op-
erator’s position at the steering handle,
especially not when you turn the ma-
chine.
Riding on the implement during opera-
tion or in transport is not permitted.
If clogging occurs in the implement, turn
off the engine and clean the implement
with an appropriate tool.
In case of damage to the two-wheel trac-
tor or to the implement, immediately turn
off the engine and have it repaired.
If steering causes problems, immedi-
ately bring the two-wheel tractor to a halt
and turn it off. Have the malfunction re-
moved without delay.
To prevent the tractor from sliding on
slopes make sure it is secured by an-
other person using a bar or a rope. This
person must be located at a higher po-
sition than the vehicle at a safe distance
from the attachment at work.
If possible, always work diagonally to
the slope.
End of Operation
Never leave the two-wheel tractor unat-
tended with the engine running.
Before you leave the two-wheel tractor,
turn off the engine. Then close fuel taps.
Secure two-wheel tractor against unau-
thorized use. If tractor is equipped with
ignition key, remove the key. For all other
versions, remove spark plug connector.
Implements
Only mount implements with the engine
and PTO switched off.
Always use appropriate tools and wear
gloves when changing implements and
parts thereof.
For mounting and removing implements
bring support leg into proper position
and ensure stability.
Secure two-wheel tractor and imple-
ments against rolling off (parking brake,
wheel chocks).
Beware of injuries while coupling imple-
ments.
Hitch implements as specified and only
couple at specified points.
Secure two-wheel tractor and implement
against unauthorized use and rolling off
when you leave the machine. If neces-
sary, install transport or security devices
and secure.
Hoeing Attachment
When hoeing and tilling on difficult
ground (stony, hard etc.) the machine
may give sudden jerking movements in
an upward and forward direction and
therefore extra care should be taken
under these conditions.
Adjust protective cover of hoeing attach-
ment so that only those parts of tools
which penetrate the soil are not covered.
When hoeing, make sure hoeing skid is
adjusted properly.
1. Safety Instructions
1
