11
THIS SECTION IS FOR TRACTORS WITH AN
ELECTRIC ATTACHMENT CLUTCH
STEP 14: (SEE FIGURE 14)
• Turn the clutch idler assembly upside down.
• Hook the long end of the spring onto the end of the
bolt that extends through the nut on the bottom of the
upper idler arm. Install a 3/8" hex lock nut onto the
bolt, leaving enough space for the spring to pivot.
FIGURE 14
FIGURE 16
STEP 16: (SEE FIGURE 16)
• Attach each rear pulley frame bracket to the inside of
the clutch/idler assembly using two 5/16" x 3/4" hex
bolts, 5/16" washers and 5/16" nylock nuts.
• Attach each front pulley frame bracket to the inside
of the clutch/idler assembly using two 5/16" x 1" hex
bolts, four 5/16" washers and two 5/16" nylock nuts.
STEP 15: (SEE FIGURE 15)
• Insert tensioning chains through the holes shown and
attach to the springs on the upper and lower idler arms.
• Install a 3/32" hairpin cotter in the 5th link of the chain
attached to the upper idler arm.
• Install a 3/32" hairpin cotter in the 4th link of the chain
attached to the lower idler arm.
FIGURE 15
STEP 17: (SEE TABLE 1)
•
Two different length drive belts are included with
your snow thrower. Use the table below to select
the correct drive belt for your type tractor. The part
number is printed on the outside of the belt.
•
Set aside the belt that is not for your tractor to avoid
accidentally using it.
SELECT THE CORRECT DRIVE BELT
(Electric clutch tractors with a single front deck
suspension bracket)
55" BELT (PART #46989)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
(LT) Lawn Tractor
38", 42"
Electric
56" BELT (PART #48138)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
(LT) Lawn Tractor
48"
Electric
(GT) Garden Tractor
48", 54"
Electric
TABLE 1
3/8" HEX
LOCK NUT
SPRING
ATTACH
LONG
END OF
SPRING
HERE
TENSIONING CHAIN
(lower idler arm)
TENSIONING CHAIN
(upper idler arm)
3/32" HAIRPIN
COTTER IN
5th LINK
3/32" HAIRPIN COTTER
IN 4th LINK
5/16" x 1" HEX BOLT
5/16" x 3/4"
HEX BOLT
5/16" NYLOCK NUT
5/16" WASHER
5/16"
NYLOCK NUT
(2) 5/16" WASHERS
