6
12. Assemble a wheel with the valve stem facing out onto
the axle. Assemble a hub cap (Q) by pressing or tapping
it onto the axle. Repeat on other end of axle. See fi gure
6.
FIGURE 5
FIGURE 4
10. Place the front tongue inside the rear tongue as shown
in fi gure 5. Fasten the tongues together using a 3/8" x
4" hex bolt (A) and a 3/8" hex lock nut (M).
Tighten,
leaving the nut just loose enough that the tongues can
pivot freely. See fi gure 5.
11. Insert the 3/8" x 4" clevis pin (G) through the tongues
and secure with a 1/8" hairpin cotter (N), as shown in
fi gure 5.
8. Assemble the hitch bracket to the front tongue using
two 3/8" x 1" hex bolts (B), and 3/8" hex lock nuts (M).
Tighten.
See fi gure 4.
9. Assemble the leg stand bracket to the front tongue using
two 5/16" x 1" hex bolts (C) and 5/16" hex lock nuts (L).
Tighten.
See fi gure 4.
FIGURE 7
13. Turn the wheel support over to rest on the wheels.
Place the latch stand bracket onto the tongue, sliding it
underneath the latch lock. Turn the latch stand plate as
shown in fi gure 7. The tabs at the ends of the channels
must face the rear. Place the latch stand plate down
onto the latch stand bracket. See fi gure 7.
FIGURE 6
ENGLISH
(Q) HUB CAP
WHEEL
AXLE
FRONT
TONGUE
(M) 3/8" HEX
LOCK NUT
(A) 3/8" x 4"
HEX BOLT
(G) 3/8" x 4"
CLEVIS PIN
(N) 1/8" HAIRPIN
COTTER
FRONT
TONGUE
(B) 3/8" x 1"
HEX BOLT
(M) 3/8" HEX
LOCK NUT
HITCH
BRACKET
LEG STAND
BRACKET
(C) 5/16" x 1"
HEX BOLT
(L) 5/16" HEX
LOCK NUT
LATCH
STAND
BRACKET
LATCH
STAND
PLATE
TAB AT
REAR
LATCH
LOCK
14. Place the poly tray down onto the wheel support and the
latch stand plate. Fasten the tray to the wheel support
using eight 5/16" x 3/4" truss head bolts (F) and 5/16"
hex lock nuts (L). Fasten the tray to the latch stand plate
and latch stand bracket using four 1/4" x 1" hex bolts
(E), 1/4" fl at washers (J) and 1/4" hex lock nuts (K).
Do
not tighten yet.
See fi gure 8.
