Agri-Fab 45-0329, Owner'S Manual

Page: 6 / 24

6
FIGURE 4
12. Turn the spreader upright on its wheels.
13. Assemble the flow control mounting tube to the hitch
tube using two 5/16" x 1-3/4" hex bolts (A), 5/16" lock
washers (l) and 5/16" hex lock nuts (G).
DO NOT
TIGHTEN YET. See figure 5.
14. Assemble the vinyl cap (T) onto the flow control
mounting tube. See figure 5.
FIGURE 5
9. Assemble a spacer (Q), a 1-5/8" flat washer (L), a
wheel (air valve facing out) and another 1-5/8" flat
washer (L) onto the end of the axle that has both the
large and small holes . See figure 4.
10. Install a 1/8" x 1-1/2" cotter pin (N) into the small hole
in the end of the axle. See figure 4.
11. Open the bail on the drive pin (W) and install it
through the wheel and the large hole in the axle.
Close the bail to lock the pin in place. See figure 4.
FIGURE 6
15. Assemble the flow control mounting bracket and the
tube support strap to the flow control mounting tube
using two 5/16" x 1-3/4" hex bolts (A), four 5/16"
washers (K), two 5/16" lock washers (I) and two 5/16"
hex lock nuts (G).
DO NOT TIGHTEN YET. See
figure 6.
16. Remove the preassembled bolt and nut from the front
of the hopper. Attach the tube support strap to the
hopper and hopper strap using the bolt and nut you
removed.
TIGHTEN. See figure 6.
(G) 5/16" HEX
LOCK NUT
(A) 5/16" x 1-3/4"
HEX BOLT
(K) 5/16"
FLAT WASHER
PREASSEMBLED
BOLT AND NUT
TUBE
SUPPORT
STRAP
HOPPER
STRAP
OF
F
ON
1
2
3
4
6
7
8
9
10
5
(I) 5/16" LOCK
WASHER
(W) DRIVE PIN
AIR VALVE
(Q) SPACER
(L) 1-5/8" DIA.
FLAT WASHER
(N) 1/8" x 1-1/2"
COTTER PIN
(A) 5/16" x 1-3/4"
HEX BOLT
(G) 5/16" HEX
LOCK NUT
(I) 5/16" LOCK
WASHER
(T) VINYL CAP
17. TIGHTEN the two bolts which fasten the flow control
mounting tube to the hitch tube. DO NOT TIGHTEN
the two bolts which fasten the flow control mounting
bracket to the flow control mounting tube.
ENGLISH
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com