AGRETO PFM II
© AGRETO electronics GmbH
page:9
Install on each of the two screws a washer, a
cable eye, again a washer, a locking ring and a
hex nut.
Tighten the two nuts with the wrench.
When tightening, ensure not to rotate the cable
lugs and possibly the cable is damaged.
Route the cable to the hitch of the press in
protected places and fasten the cable at
suitable points with the cable ties.
Keep in mind that the cable must be so long that the plug in the attached
state is in the cab of the tractor. The excess cable length best to be fixed at
a sheltered position at the press. The cable should not be reduced.
6.4
Installation of the display unit
For mounting the display unit the bracket has to be removed. To do this,
remove the top thumbscrew completely and loosen the lower thumbscrew
so far, until the lower part of the bracket can be pulled sideways.
Find a suitable location in the cab for mounting the display unit. You can
use the 6 holes in the bracket for mounting on a bracket, a mounting panel
or directly to a cab upright.
If you perform drilling operations make sure that you do not damage any
cables or other parts. A direct drilling in a cabin part, you should only
perform according to operating instructions or consult the manufacturer. If
you are using the two supplied self-drilling screws, you need to use
depending on the material thickness a drill with a diameter of 3.5 to 4 mm.
After the bracket is mounted, mount the display unit back to the bracket.
Make sure that the slot of the lower bracket fits between spacer and thumb
screw (and not between the plastic housing and spacer)
Rotate the display device in the desired direction and tighten the upper
thumbscrew.
Connect the power cable to an electrical circuit, which is connected to the
ignition. If you do not want to connect the power supply directly, you can
also mount a plug for the cigarette lighter or power outlet. Do not remove
the fuse holder with the fuse.
