8
MOUNTING THE BLADE
First make sure that the machine is unplugged.
1.
Remove the blade guard by loosening the butterfly screw and
lift away.
2.
Reach under the edge of the table and pull each of the 4
locking pins against the spring and rotate 90 degrees, this will
allow the table to be lifted away.
3.
Release the shroud by pulling up slightly and away.
4.
Use the 8mm combination wrench to keep the arbor
from turning and loosen the arbor nut with the 19mm
combination wrench (it is a standard right-hand thread, so
turn anticlockwise to loosen).
5.
Remove the nut, spring washer and outer blade flange
6.
When mounting the blade ensure that the direction arrow
marked on the motor plate of the machine matches direction
arrow on the blade. Also ensure that the blade bore matches
the inner blade flange.
7.
The protruding edge of the inner flange should be facing the
blade. Then mount the blade to the inner flange and add the
outer flange. Add the arbor nut and tighten to 15-25 Nm. The
rest of the replacement is the opposite of removal
The inner blade flanges is specific to the blade arbor bore diameter
of 25.4mm (1”) Check the inner flange to ensure that the size
matches the bore of the blade which you intend to use.
Inspect the blade before use. It must not be cracked, warped or
damaged in any way that would cause a hazard in operation. Loose diamond segments can be ejected at high
speed, causing possible injury. Always check that the diamond segments are not under cut. If the diamond
segments are thinner or nearly thinner than the blade core, the kerf will be too tight fitting and could easily
lead to jamming or kickback.
Ensure that the flanges and blade bore are clean and undamaged and that everything fits properly. The
flanges may not be used if they are warped, the surface is uneven, burred or if they are dirty. The arbor nut and
arbor threads must be undamaged. Inspect the blades for segment damage, arbor hole damage or any other
damage which could cause hazardous operation.
WARNING: Do not attempt to mount a blade which does not match the mounting hardware. It will lead
to eccentric running and vibration which will be uncontrollable.
ADJUSTING THE BLADE GUARD
The blade guard must ALWAYS be used whenever cutting to avoid a hazard. Adjust the guard by loosening
Locking pin
15
14
88
Inner Flange
Blade
Outer Flange
Nut
Washer
Summary of Contents for 0.75KW115V
Page 12: ...12 WIRING MOTOR SWITCH WHITE BLACK RED TERMINAL BLOCK CAPACITOR 3 WAY TERMINAL BLOCK ...
Page 13: ...13 ...
Page 16: ...16 ...
