10
BEVEL CUTS
The motor assembly may be tilted up to 45 degrees for performing
bevel cuts. To adjust the bevel angle, loosen the two hand knobs
on the right and left sides of the machine, adjust to the desired
angle, and then retighten the knobs.
OPERATION
Before cutting
•
Ensure that the operating environment is free or clutter
•
Fill the water tray
•
Refer to the scale on the table and set the cutting guide to the desired width of cut
•
Adjust the blade guard to be as close as possible to the workpiece
•
Ensure that all bystanders are at a safe distance.
•
Ensure that the equipment is grounded.
•
Ensure that all safety equipment is in place.
CAUTION: Never cut dry and do not allow the water tray to run dry. Blade life will be severely shortened.
CUTTING TECHNIQUE
•
Start the machine by pressing the green ON button
•
Allow the motor to reach full speed, then hold the tile firmly, and steadily feed the tile to the blade
•
Do not allow the machine to bog down. Limit your feed pressure to keep the blade spinning at high
speed.
•
Do not push too hard at the end of the cut.
•
Keep your hands away from the blade
STOPPING
Press the red OFF button to stop the machine. After the motor is
shut off, the blade will continue spinning for a time.
WARNING: Keep hands and objects away from the blade while
it is still spinning.
Bevel angle knob
switch
Summary of Contents for 0.75KW115V
Page 12: ...12 WIRING MOTOR SWITCH WHITE BLACK RED TERMINAL BLOCK CAPACITOR 3 WAY TERMINAL BLOCK ...
Page 13: ...13 ...
Page 16: ...16 ...
